CLICK HERE TO RETURN TO HOME PAGE
Line Swivel

Above
Specifications 00505
Operating Instructions 00505
Specifications 00505A
Operating Instructions 00505A
Catalog Page
                                   

Quality,
by Design

 

00505.2.jpg (65268 bytes) 
Series 00505 Line Swivel. 
NOT SUITABLE FOR DIRECTIONAL DRILLING

DCD Line Swivels, (e.g. 00505-000) are typically constructed with a thrust bearing for tensile load and a radial bearing for bending load. They combine a high safe working load with a compact design. All sizes incorporate an oil seal and are manufactured from high strength Stainless Steel.

DCD has recently added Locking Line Swivels (e.g. 00505-000A) to their product line these are typically constructed with a Bronze thrust bearing for tensile load and a Radial bearing for bending load. They combine a high safe working load with a compact design. All sizes incorporate an oil seal and are manufactured from high strength Stainless Steel. Due to the use of a Bronze bearing in place of a Roller bearing, rotation will only continue up to a certain load, much less than the Safe Working Load. Once past this point, then rotation will only occur when pulling tension is relieved. 

Sizes up to and including 00505-040 are manufactured from high strength Stainless Steel. The three largest sizes shown on the Specification Sheet are manufactured from special Alloy Steel and are Black Oxide coated.  The different material allows higher working loads while retaining a compact design.

All sizes incorporate an oil seal and sizes 00505-020 and larger are supplied with a grease point for lubrication.  This is particularly useful if used if used in overhead applications where high speed rotation is possible and lubrication is suggested after each use.

All sizes of both types are pull tested to verify the 3:1 safety factor and all (swiveling) sizes are fully capable of rotation at full working load.  Test certificates are available upon request. 

Sizes 00505-025 & 00505-025A and larger are supplied with hexagon Clevis Pins. Smaller sizes have slotted Clevis Pins. 

For clevis detail and pin replacement see web page  Series 00000.  Under no circumstances should alternate Clevis Pins be used. 

Note:  Line swivels are not designed to run around bull wheels and severe damage or injury may be incurred if this is done.

Key Benefits

  • Compact design
  • High safe working load
  • Manufactured from high tensile stainless or alloy steel

Back to top

 

* Note: To print on one page, it may be necessary to decrease left and right margins in page setup

Send mail to sales@dcddesign.com with questions or comments about anything DCD related. We want to hear from you!