|
Above
Specifications
Operating Instructions
Catalog Page
Quality,
by Design
| |
Series 00600 Irrigation
puller
Specifically designed for installation of PVC or PE duct by Vibratory Plow, the
product is particularly suited to agricultural applications because of the quick
installation and removal. DCD Plow-Grips are comprised of a stainless
steel body and a clevis head with 8 links of hardened steel chain attached and
hardened Stainless Steel expanding jaws that grip the inside of the ducting.
Since there are various outside and inside diameters for ducting, the DCD
Plow-Grip now has a single sleeve with a different bore size at each end.
Should your ducting not fit at one end, reverse the sleeve and check the bore at
the other end. The two sleeve sizes will cover 80# and 100# PE duct and
Sched. 40 up to SODR 26 PVC duct.
Changing the sleeve from one end to the other is easy - simply unscrew the two
hexagon nuts at the end of the puller, remove the tapered mandrel and jaws,
slide the outer sleeve off and turn it end for end, then re-assemble all the
items. The process takes about two minutes and is very simple.
Back to top
To assemble the Plow-Grip to the ducting, the head is pushed against a spring
which contracts the hardened steel jaws. The Plow-Grip can then be sleeved
over the ducting. When the head is released, the jaws expand inside the
duct and bite into the duct wall. As the pulling load is applied, it
increases the bite of the jaws. When the pull is complete, pushing the
head down will again contract the jaws allowing the Plow-Grip to be removed from
the ducting.
Typical vibratory plow action causes a very fine dust or
powder to surround the puller, it is recommended that the user periodically
dismantle the product for thorough cleaning. A wrench is the only tool
required for complete dismantling.
Key Benefits:
- no tools required for installation
- outside sleeve prevents stretching and cracking of
pipe
- expanding jaw grips tight
Back to top
|
