CLICK HERE TO RETURN TO HOME PAGE
Carrot Pullers
|
|
|
Quality,
|
These products are designed to install Polyethylene Ducting using a screw-in tapered thread to grip the Inside diameter of the duct. They are typically used to install innerduct or sub-duct inside a larger duct, but they may also be used for Directional Drilling applications. Because there are no moving parts, they are reliable and maintenance free. The pulling eye is designed with cutting edges to actually cut a thread in the bore of the ducting as it is being screwed in, much the same way as using a tap to cut a thread in steel. This helps to ensure a reliable grip. Installation typically requires 7 or 8 full threads of contact to give a grip stronger than the ducting itself. The Lug Type Series 00604 are useful if attaching directly to a Line Swivel, 00505 series, or other clevis type connector. While the Clevis Type Series 00605 are more useful if attaching to a pulling rope or wire with an eye that can be slotted into the Puller clevis and simply attached with the pin provided. Care should be taken at all times not to exceed the yield value of the ducting since this may cause permanent deformation to the duct as well as loss to the integrity of the polyethylene. The Duct Pullers are installed quickly and easily and require no special tooling. They are manufactured out of Steel and Chrome plated for durability. Key Benefits
|
|
* Note: To print on one page, it may be necessary to decrease left and right margins in page setup Send mail to sales@dcddesign.com with questions or comments about anything DCD related. We want to hear from you! |
