CLICK HERE TO RETURN TO HOME PAGE
Application Methods

Above
                                   

Quality,
by Design

 

TUBE_LUBE®326 can be applied using the 20" hose and several of DCD  Duct Entry products.  These product have been designed incorporating a quick disconnect spray nozzle, see examples below

32500-lube.jpg (1166477 bytes)

The Duct Entry Guide (32500 series): This product fits right into the duct opening and has a roller that the cable must pass over.  The unit is fitted with a Spray Nozzle that when hooked up, places the lubricant right onto the cable as it passes under the nozzle.
Back to top

Flex Cable Guide Lube.jpg (524072 bytes)

The Flexible Guides (32600 series). This product attaches to Duct Entry Adaptors and these parts also have a Spray Nozzle to apply the lubricant right onto the cable as it enters the duct.
 Back to top

32550-BL.jpg (556023 bytes)

The Split Entry Bells (32550 series): These are a cable entry guide that can be removed easily after installation and are also available with a Spray Nozzle such that again, the lube can be sprayed right onto the cable.
Back to top

Hand spray.jpg (376247 bytes)

Finally a Manual spray wand is included with both types of Applicator Kits so that the hose may be connected to the spray wand and then applied onto the cable drum itself or any other point in the cable travel before entering the duct.

Back to top

 

* Note: To print on one page, it may be necessary to decrease left and right margins in page setup

Send mail to sales@dcddesign.com with questions or comments about anything DCD related. We want to hear from you!