CLICK HERE TO RETURN TO HOME PAGE
Wire Mesh Pulling & Support Grips
|
|
|
Quality,
|
DCD cable grips are hand-woven by experienced trades people and this guarantees a consistent level of high quality. DCD grips are reverse woven (see photo below of typical grip end), creating a loop at the end of the grip instead of being soldered or crimped together . The wire is joined under the crimped head and testing proves this is never the weakest link of the product.
The looped pulling head is actually a separate wire rope eye which is placed inside the swage sleeve along with the wire mesh strands. The swage sleeve is then crimped forming an extremely effective anchor point for both the looped head and the wire mesh. Testing proves this is never the weakest link of the product. The flexible eye allows cable to be pulled more easily through smaller ducting. The DCD cable grips enclose the cable firmly over the entire length of the mesh. They are made of high tensile steel strands. Depending on the type of grip, the strand comprises 7, 12 or 19 wires. By selecting the most suitable strand, the tension distribution characteristics can be adjusted to suit the requirements. In addition to the grips listed, DCD can also
supply special products for particular fields of application. Information on
these will by supplied upon request. |
|
* Note: To print on one page, it may be necessary to decrease left and right margins in page setup Send mail to sales@dcddesign.com with questions or comments about anything DCD related. We want to hear from you! |
