Duct Rodders Accessories

Home > Duct Rodders > Accessories

---

Splice Connectors (Series 57100)
These products are used to repair a break in the rod. Having a solid section in the middle of the rod may cause problems with bending at that point and care should be taken when winding rod with a solid connector. The five larger sizes are stainless steel and can be glued or screwed on, the two smaller sizes are brass and must be glued.

 

 

---

Flexible Guide Heads (Series 57110)
Flexible Guides are used for leading the rod around tight bends. The two larger sizes are stainless steel, the smaller sizes are brass.

 

 

 

---

Pulling Eyes (Series 57120)
Pulling Eyes are used for tying wire or pull tape to the end of the rod or used as a leader. They screw directly onto the rod end and are supplied with the rodder.

 

 

 

---

Rod Ends (Series 57130/57135)
These are used as a means of attaching accessories to the rod. Brass male rod ends are standard on the leading end of the smaller 1/8" and 3/16" rodders which have no fitting on the back end. The large rodders are all fitted with Female ends on the back end of the rod.

 

 

---

Swivel Connectors (Series 57140)
The Swivel Connector allows any attachment to the rod to rotate freely. These have bronze bearings and are supplied as standard on all 1/4" and larger rodders.

 

 

 

---

Roller Guides (Series 57150)
The Roller Guide is used to push through conduit with cable already in place. The rollers prevent the rod from wedging in under the cable as they rotate on hardened shoulder bolts. The shank attaches directly to the swivel rod end to provide axial rotation.

 

 

---

Clevis Ends (Series 57160)
The Clevis allows attachment of pulling ropes etc. without the need of extra shackles.

 

 

 

 

---

Miscellaneous (Series 57170)
Other accessories, such as Rod Grippers and glue, are also available for use with DCD rodders.

 

 

 

 

---