Wire Mesh Pulling & Support Grips

Home > Wire Mesh Pulling & Support Grips

Pulling Grips	Support Grips
Wire Grip Swivel	Grip Selection Guide

Cable Grips DCD cable grips are hand-woven by experienced trade's people ensuring a consistent level of high quality. DCD grips are reverse woven (see photo below of typical grip end), creating a loop at the end of the grip instead of being soldered or crimped together. The wire is joined under the crimped head and testing proves this is never the weakest link of the product.

The looped pulling head is a separate wire rope eye which is placed inside the swage sleeve along with the wire mesh strands; the swage sleeve is crimped forming an extremely effective anchor point for both the looped head and the wire mesh. The flexible eye allows cable to be pulled more easily through smaller ducting. DCD cable grips are made of high tensile steel strands comprised of 7, 12 or 19 wires; by selecting the most suitable strand, the tension distribution characteristics can be adjusted to suit the requirement. In addition to the grips listed, DCD can also supply special products for particular fields of application; information on these will be supplied upon request.

Pulling Grips

All DCD grips meet the highest standards in terms of material and workmanship and we are pleased to offer a wide range of grips with different designs and eye arrangements for onsite (or premise), underground or overhead installations.

Support Grips

Cable Support Grips are used for supporting any kind of cable in permanent installations. They can be used in either horizontal or vertical installations.

Tradeshows | Manufacturer's Representatives | Site Map | Resources | Contact