Pulling Harness

Home > Cable Pulling Eyes > Pulling Harness

Pulling Harness (Series 25000)
The purpose of the Pulling Harness is to allow single or multiple pulls at one time by attaching one or two cables to the one Pulling Harness. The Harness legs are manufactured from aircraft quality galvanized wire rope while the Connector end is manufactured from Stainless Steel.

The Double Leg Harness units are staggered in length so the individual connections are not interfering with each other. The *safety factor of 3:1 is based on equal pull on both legs.

The Single Harness is supplied with 1 Hex Key and 2 Set Screws. The Double leg Harness is available in Long or Short configurations and each is supplied with 1 Hex Key and 4 Set Screws. Both the Hex Key and the Set Screws are available separately.

Cable sizes that can be pulled with these harnesses are 2/0 to 4/0 AWG.